Page 343 - Manual Oficina Polaris RZR 570 13-18

FINAL DRIVE

2. Remove the large end of the boot from the plunging 5. Make sure the circlip w is on the shaft and not left in
joint and slide the boot down the shaft. the joint.

3. Clean the grease from the face of the joint and place 6. Remove the boot from the shaft.
the drive shaft in a soft-jawed vise.
CAUTION
4. Using a soft-faced hammer, or brass drift, strike the
inner race of the joint to drive the joint off the shaft. Complete disassembly of the plunging joint is NOT
Be sure to tap evenly around the joint to avoid recommended. The internal components are precision
binding. fit and develop their own characteristic wear patterns.
Intermixing the internal components could result in
looseness, binding, and/or premature failure of the joint.

7

IMPORTANT
Tap on inner race only!
IMPORTANT

If the grease in the joint is obviously contaminated with
water and/or dirt, the joint should be replaced.

7. Thoroughly clean the joint with an appropriate
solvent and dry the joint to prevent any residual
solvent from being left in the joint upon reassembly.
8. Visually inspect the joint for damage. Replace if
needed.
9. Clean the splines on the end of the shaft and apply a
light coat of grease prior to reassembly.

9926813 R06 - 2013-2016 RZR 570 Service Manual 7.19
© Copyright Polaris Industries Inc.