Page 342 - Manual Oficina Polaris RZR 570 13-18

FINAL DRIVE

13. Slide the joint onto the drive shaft splines and align 19. While pulling out on the CV shaft, fully extend the CV
the circlip with the lead-in chamfer on the inner race joint and slide a straight O-ring pick or a small slotted
of the joint. screw driver between the small end of the boot and
the shaft. This will allow the air pressure to equalize
in the CV boot in the position that the joint will spend
most of its life. Before you remove your instrument,
be sure the small end of the boot is in its correct
location on the shaft.
20. Install and tighten the small clamp r on the boot
using the appropriate clamp tool.

14. Use a soft-faced hammer to tap the joint onto the
drive shaft until it locks into place.
15. Pull on the joint to make sure it is securely locked in
place.
16. Remove excess grease from the CV joint's external
surfaces and place the excess grease in the boot.
17. Pull the boot over the joint and position the boot lips Axle Boot Clamp Tool: PU-48951
into the grooves on the joint housing and shaft. Make
sure the boot is not dimpled or collapsed. or
CV Boot Clamp Pliers: 8700226
18. Install and tighten the large clamp e using the
appropriate clamp tool.
INNER PLUNGING JOINT / BOOT
REPLACEMENT
1. Use a side cutters to cut and discard the boot clamps
q.

Axle Boot Clamp Tool: PU-48951
or
CV Boot Clamp Pliers: 8700226

7.18 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.