Page 347 - Manual Oficina Polaris RZR 570 13-18

FINAL DRIVE

3. Support U-joint in vise as shown and drive inner yoke 2. Tighten vise to force bearing caps in.
down to remove remaining bearing caps.

3. Using a suitable arbor, fully seat the bearing cap in
4. Force U-joint cross to one side and lift out of inner one side. Continually check for free movement of
yoke. bearing cross as bearing caps are assembled.

7

4. Install snap ring to contain bearing cap just installed.
ASSEMBLY Repeat procedure for other side.
1. Install new bearing caps in yoke by hand. Carefully 5. Install outer yoke, aligning marks made at
install U-joint cross with grease fitting properly disassembly and repeat Steps 1-3 to install bearing
positioned inward toward center of shaft. Take care caps on outer yoke.
not to dislodge needle bearings upon installation of
cross joint.

9926813 R06 - 2013-2016 RZR 570 Service Manual 7.23
© Copyright Polaris Industries Inc.