Page 163 - Manual_Polaris_RZR_ProXP-20-21

ENGINE / COOLING SYSTEM

9. Remove six fasteners a retaining the head pipe to HEAD PIPE / TURBO INSTALLATION
the cylinder head.
CAUTION
Do not handle the turbo/head pipe assembly by the
actuator rod. The rod will become damaged and the
turbo will not function properly.

IMPORTANT
If replacing the turbo assembly, pour a few drops of new
engine oil down the oil supply hole and rotate the turbo 3
by hand. Never used compressed air on the turbo
assembly to rotate the vanes.

10.Slide the head pipe off the studs and remove the
head pipe/turbo from the vehicle.

CAUTION
Do not handle the turbo/head pipe assembly by the
actuator rod. The rod will become damaged and the
turbo will not function properly.

1. Install a new head pipe gasket and install the head
pipe/turbo assembly on the cylinder head studs.
2. Install the six fasteners retaining the head pipe to the
cylinder head. Torque fasteners to specification.
TORQUE
Head Pipe Screws:
17 ft-lb (23 Nm)
Head Pipe Nuts:
26 ft-lb (35 Nm)

3. Tighten the lower rear turbo bracket fasteners. Torque
fasteners to specification.

TORQUE
Turbocharger Bracket Lower Fasteners:
42 ft-lb (57 Nm)

4. Install the fasteners retaining the turbo to the
mounting bracket. Torque fasteners to specification.
TORQUE
Turbocharger Mounting Fasteners:
18 ft-lb (24 Nm)

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 3.19
© Copyright Polaris Industries Inc.