Page 186 - Manual_Polaris_RZR_ProXP-20-21
P. 186

ENGINE / COOLING SYSTEM

                STARTER MOTOR INSTALLATION                           9. Install inner PVTcover baffle. Torque fasteners to
                                                                        specification.
                1. Inspect and replace starter motor O-ring if needed.
                2. Lubricate starter motor O-ring with fresh engine oil.
                3. Install the starter motor onto the engine case.
                4. Hand tighten the upper starter mounting bolt / stud.
                5. Install and torque the lower mounting bolt to
                   specification.
                                     NOTICE
                  Tighten the lower starter bolt first, as the bottom hole
                  acts as a pilot hole to properly align the starter drive
                  (bendix) with the flywheel. This helps prevent binding
                                and starter damage.


                6. Torque upper starter mounting screw to specification.
                                                                                          TORQUE
                7. Install (-) negative battery cable to the upper starter
                   mounting bolt / stud. Torque nut to specification.          Inner PVT Cover Baffle Fasteners:
                                                                                       7 ft-lbs (10 Nm)
                                     TORQUE
                               Starter Mounting Bolts:               10.Install the drive clutch. Torque bolt to specification.
                                  7 ft-lb (10 Nm)
                                Starter Cable Nuts:                                       TORQUE
                                  30 in-lb (3 Nm)
                                                                                  Drive Clutch Retaining Bolt:
                                                                                       96 ft-lb (130 Nm)
                8. Install inner PVTcover.
                                                                     11. Install the driven clutch. Torque bolt to specification.
                                                                                          TORQUE
                                                                                  Driven Clutch Retaining Bolt:
                                                                                       70 ft-lb (95 Nm)

                                                                     12.With the clutch spreader tool installed, loop the belt
                                                                        over the drive clutch and over part of the driven
                                                                        clutch.
                                                                     13.Rotate driven clutch and walk the belt into the clutch.
                                                                     14.Remove clutch spreader tool from driven clutch.

                                                                     15.Rotate / spin the driven clutch and belt approximately
                                                                        5-7 times to properly seat the belt in the driven clutch.
                                     TORQUE                          16.Install outer clutch cover and nine screws. Torque to
                            PVT Inner Cover Fasteners:                  specification.
                        STEP 1: Torque to 37 ft-lbs (50 Nm).                              TORQUE
                   STEP 2: Install through bolts by adjusting the
                             transmission accordingly.                            Outer Clutch Cover Screws:
                 STEP 3: If previously removed, loosely install bolts                   35 in-lb (3 Nm)
                                     by hand.
                        STEP 4: Torque to 37 ft-lbs (50 Nm).
                        STEP 5: Torque to 50 ft-lbs (68 Nm).
                  STEP 6: If previously removed, torque to 37 ft-lbs
                                     (50 Nm)





                3.42                                                       9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
                                                                                                © Copyright Polaris Industries Inc.
   181   182   183   184   185   186   187   188   189   190   191