Page 189 - Manual_Polaris_RZR_ProXP-20-21
P. 189

ENGINE / COOLING SYSTEM

                   INSTALLATION                                          2. Tighten the drive bolt e until the cylinder r bottoms
                                                                            out against the crankcase.
                   1. Install new seal w into crankcase. Thread the drive
                      bolt of special tool PU-52493 q into the crankshaft.









                                                                                                                              3









                                                                         3. Once the seal is properly installed, loosen the drive
                                                                            bolt e and remove special tool PU-52493 from the
                                       IMPORTANT
                                                                            crankshaft.
                    The orientation of the seal is critical. Install the seal with
                         the flat side of the seal facing out as shown.  4. Refer to PVT Inner Cover Assembly page  .
                                                                         5. Test drive the vehicle and recheck for leaks before
                                                                            putting back into service.


















































                   9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual                                           3.45
                   © Copyright Polaris Industries Inc.
   184   185   186   187   188   189   190   191   192   193   194