Page 187 - Manual_Polaris_RZR_ProXP-20-21

ENGINE / COOLING SYSTEM

17.Install clutch intake duct, and tighten two worm 4. Remove the isolator bolt w and remove the isolator.
clamps to specification.
5. Install new isolator and bolt. Torque fastener to
TORQUE specification.
Worm Clamps 6. Lower the lift or jack and align the isolator tang with
35 in-lbs (4 Nm) the holes in the frame. Install isolator to frame
fasteners. Torque fasteners to specification.
7. Install rear skid pan. Torque fasteners to
18.Connect the battery. Torque fasteners to
specification. specification.
TORQUE
TORQUE 3
Engine Mount Isolator Bolts:
Battery Fasteners:
40 ft-lbs (54 Nm)
60 in-lbs (7 Nm)
Engine Mount Nuts:
22 ft-lb (30 Nm)
FRONT ENGINE MOUNT ISOLATOR
Skid Pan Fasteners:
REPLACEMENT 8 ft-lbs (11 Nm)
1. Remove the rear skid plate fasteners q and remove
the skid plate from the vehicle.

2. Using a commercially available transmission lift or
pump jack, lift the front engine mount to take the
weight off the isolators.
3. Remove the fasteners q retaining the isolator
mounts to the frame.

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 3.43
© Copyright Polaris Industries Inc.