Page 108 - Manual Oficina XP 1000 14-16

ENGINE / COOLING SYSTEM

ENGINE INSTALLATION 4. Use the overhead or portable engine hoist and
Use the following procedure to reinstall the engine suitable engine straps to lower the engine into the
assembly. vehicle frame.
1. Attach engine with suitable lifting straps to an NOTE
overhead or portable engine hoist. Have an assistant help guide the engine in and out of

2. Remove the engine stand adapter plate and install the vehicle while using an engine hoist to prevent
the starter motor back onto engine. Torque starter personal injury or damage to vehicle components.
motor bolts to specification.
5. Align both the front and rear engine mounting
3. Install transmission joint bracket onto engine and locations. Install and hand tighten the four front
torque fasteners to specification in sequence.
engine mounting nuts q and bolts w.

NOTE
DO NOT torque fasteners at this time.

6. Align transmission joint mounting holes with the
transmission front mounting holes.

7. Install the Clutch Center Distance Tool (PU-50658-A)
onto the crankshaft e and transmission input shaft
to properly position the clutch center distance. The
pictures below show the tool properly installed r.

TORQUE
Starter Motor Bolts:
7 ft-lb (10 Nm)

Trans Joint Bracket Bolts:
44 ft-lb (60 Nm)

3.30 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.