Page 148 - Manual Oficina XP 1000 14-16
P. 148
ENGINE / COOLING SYSTEM
BALANCE SHAFT INSTALLATION 5. Install the balance shaft, placing the tooth with the
1. Clean the upper crankcase balance shaft bearing alignment dot r in-line with the dot on the crankshaft
bore surfaces. gear (see reference images below).
2. Align tab of new balance shaft bearings q with the
slot in each bearing bore of crankcase. Press
bearing insert firmly into place.
LOWER CRANKCASE PREPARATION
NOTE
3. Apply Polaris PS-4 engine oil to both balance shaft
journals w. Always replace plain bearings when the crankcase or
connecting rods have been disassembled. Refer to
bearing selection procedures.
1. Remove all traces of crankcase sealant from the
crankcase mating surfaces. Inspect the surfaces
closely for nicks, burrs or damage.
2. Clean bolt hole threads to remove any oil or
crankcase sealant.
3. Inspect crankcase bearing bores. Replace the
crankcase assembly if a bearing bore is galled or if
bearing inserts have rotated in the case.
4. Be sure alignment pins are in place where used.
5. Refer to Engine Oil Flow Chart, page 3.5 at the
4. Rotate the crankshaft until the alignment dot e on beginning of this chapter and trace the oil paths
the crankshaft MAG end gear is visible. through the crankcase and cylinder.
6. Flush all oil passages with solvent and then warm
soapy water. Rinse with clear, warm water and dry
with compressed air.
7. Be sure passages are clean and dry before
assembling the crankcase.
3.70 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
