Page 238 - Manual Oficina XP 1000 14-16

PVT SYSTEM

PVT DISASSEMBLY (2016) 9. Mark the drive belt direction of rotation and remove
drive belt (see Chapter 5 – Belt Removal, page 5.17).
1. Place transmission in neutral.
10.Remove the driven clutch retaining bolt and driven
2. Safely raise and support the vehicle. clutch.

CAUTION CAUTION
Serious injury may result if machine tips or falls. Be Do not strike the driven clutch to free it from the
sure machine is secure before beginning this service transmission input shaft. This will damage the clutch.
procedure.

NOTE
3. Remove the left rear wheel.
For MY16 models, if the driven clutch will not
4. Remove the lower mounting bolt and nut q from the
left rear shock. Discard the nut. disengage, a commercially found 2–Jaw puller may be
used. Only pull from inside the slider pockets. Pulling
5. Swing shock outward toward the front of the vehicle. on the sheaves may cause damage to the clutch.
6. Loosen the hose clamp attaching PVT intake hose to
the outer clutch cover and disengage the hose from
the outer clutch cover.
7. Remove the eight clutch cover screws w and remove
the outer clutch cover from the vehicle.

11. Install the Drive Clutch Holding Tool on the drive
clutch.
Drive Clutch Holding Tool:
9314177-A
8. Loosen the hose clamps e attaching PVT inlet and
outlet ducts to the clutch cover. Disengage the hoses
from the clutch cover and remove the outer cover
from the vehicle.

5.14 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.