Page 282 - Manual Oficina XP 1000 14-16

TRANSMISSION

19.Remove the bearing from the reverse shaft using a 23.If necessary, disassemble the other end of the
bearing puller. Remove the retaining ring and slide reverse shaft. Remove the bearing , engagement
the washers, high gear and needle bearing off the dog, retaining ring, washer, low gear d and needle
reverse shaft. bearing f from the reverse shaft.

s Reverse Shaft h Washer

d Bearing j Low Gear
f Engagement Dog k Needle Bearing

g Snap Ring

q Bearing y Needle Bearing 24.To disassemble the shift shaft rail remove the snap
ring 2% from the end of the shift rail on either side.
w Reverse Shaft u Engagement Dog
e Retaining Ring i Sprocket

r Washers o Silent Chain
t High Gear a Input Shaft

20.Remove the retaining ring and engagement dog from
the reverse shaft.
21.Remove the retaining ring, washer, needle bearing,
and sprocket from the reverse shaft.
22.Tilt the two shafts towards each other and remove the
silent chain from the two shafts.

CAUTION
Use caution when disassembling the shift rail. The
compressed springs on the shift rail may pop off
causing eye or face injury.

6.14 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.