Page 358 - Manual Oficina XP 1000 14-16

STEERING / SUSPENSION

UPPER STEERING SHAFT INSTALLATION 4. Be sure the front wheels are pointing straight ahead
and install the steering wheel and retaining nut.
NOTE Torque the nut to specification and reinstall the
plastic wheel cover.
If steering wheel was removed, follow this procedure to
ensure the upper steering shaft is properly positioned TORQUE
on the power steering stub shaft.
Steering Wheel Nut:
65 ft-lbs (88 Nm)
CAUTION
5. Install a new upper steering shaft pinch bolt and nut.
Striking the steering wheel or steering shaft can Torque pinch bolt to specification.
permanently damage the EPS unit and cause a Power
Steering Fault. TORQUE

Upper Steering Shaft Pinch Bolt:
NOTE 15 ft-lbs (20 Nm)
Be sure upper steering shaft hardware is positioned
correctly (see Chapter 8 – Assembly View, page 8.4). 6. Reconnect both electrical harnesses onto the power
steering unit. Be sure the connectors snap into
place.
1. Install the upper steering shaft and align the skip-
tooth spline q on the power steering stub shaft with 7. Reinstall the black plastic cover over the power
the opening w in the upper steering shaft. steering unit and install the two Torx fasteners.

8. Turn the key switch on and test EPS operation.

2. Install the pivot tube and torque fasteners to
specification.
TORQUE
Pivot Tube Fasteners:
8 ft-lb (11 Nm)

3. Install the tilt shock and torque fastener to
specification.

TORQUE
Tilt Shock Fastener:
7 ft-lb (10 Nm)

8.10 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.