Page 362 - Manual Oficina XP 1000 14-16

STEERING / SUSPENSION

13. Attach shock to A-arm with fastener. Torque lower 20. Insert new A-arm bushings and pivot tube into new
shock bolt to specification. A-arm. A light press force may be needed.
TORQUE 21. Install new lower A-arm assembly onto vehicle
frame. Torque new bolt to specification.
Front Shock Mounting Bolts:
22. Insert lower A-arm ball joint end into the bearing
42 ft-lbs (57 Nm)
carrier. Install lower ball joint pinch bolt into the
bearing carrier and torque bolt to specification.
Lower A-Arm WARNING
14. Remove lower ball joint pinch bolt t from bearing Upon A-arm installation, test vehicle at low speeds
carrier. before putting into service.

TORQUE

Lower A-arm Bolts:
42 ft-lb (57 Nm)

Front Ball Joint Pinch Bolts:
42 ft-lbs (57 Nm)

FRONT STABILIZER BAR REMOVAL

1. Remove the nut q retaining the front stabilizer bar
link w to the upper control arm eon both sides.
15. Using a soft face hammer, tap on bearing carrier to
loosen the lower A-arm ball joint end while pushing
downward on the lower A-arm. Completely remove
the ball joint end from the bearing carrier.
16. Loosen and remove the lower A-arm front through-
bolt fastener y and rear through-bolt fastener u.
Remove the lower A-arm from the vehicle.

2. Remove the Fasteners retaining the stabilizer bar
mount to the frame.
3. Remove the stabilizer bar out the side of the vehicle.

17. Examine A-arm bushings and pivot tube. Replace if
worn. Discard hardware.
18. If not replacing the A-arm, thoroughly clean the A-
arm and pivot tube.
19. Install new ball joint into A-arm. Refer to “Ball Joint
Replacement” section.

8.14 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.