Page 363 - Manual Oficina XP 1000 14-16

STEERING / SUSPENSION

4. Remove the fasteners r retaining the stabilizer bar TORQUE
link to the stabilizer bar.
Stabilizer Bar Link Fasteners:
40 ft-lb (54 Nm)

FRONT STABILIZER BAR INSTALLATION

1. Install the fasteners r retaining the stabilizer bar link
to the stabilizer bar. Torque fasteners to specification. BALL JOINT SERVICE PREPARATION
TORQUE NOTE

Stabilizer Bar Link Fasteners: Do not reuse a ball joint if it has been removed. If
40 ft-lb (54 Nm) removed, it must be replaced. Use this removal
procedure only when replacing the ball joint.

1. Properly lift and support the vehicle by the frame.
2. Remove the appropriate front wheel.
3. To service the upper ball joint: Remove and
discard the two front brake caliper mounting bolts
and remove the caliper from the brake disc (see 8
Chapter 9 – Caliper Removal , page 9.21).

4. Remove and discard the upper ball joint pinch bolt.

5. If necessary, remove the lower front shock fastener
from the A-arm.
6. Remove the upper A-Arm to frame mounting bolts
2. Install the stabilizer bar from the side. and remove the A-arm from the chassis.
3. Install the fasteners retaining the stabilizer bar mount 7. To service the lower ball joint: Remove and
to the frame. Torque fasteners to specification. discard the lower ball joint pinch bolt.

TORQUE 8. Remove both A-arm to frame mounting bolts and
remove the A-arm from the chassis.
Stabilizer Bar Mount Bracket Fasteners:
17 ft-lb (23 Nm)

4. Install the nut q retaining the front stabilizer bar link
w to the upper control arm eon both sides. Torque
fasteners to specification.

9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 8.15
© Copyright Polaris Industries Inc.