Page 64 - Manual Oficina XP 1000 14-16

MAINTENANCE

STEERING

STEERING INSPECTION STEERING WHEEL FREE-PLAY
The steering components should be checked periodically Check steering wheel for specified free-play and
for loose fasteners, worn tie rod ends, ball joints and operation.
damage. Also check to make sure all cotter pins are in 1. Position the vehicle on level ground.
place. If cotter pins are removed, they must be replaced.
Replace any worn or damaged steering components. 2. Lightly turn the steering wheel left and right.
Steering should move freely through the entire range of 3. There should be about 0.8-1.0″ (20-25 mm) of free-
travel without binding. Check routing of all cables, hoses, play.
and wiring to be sure the steering mechanism is not
restricted or limited. 4. If there is excessive free-play or the steering feels
rough, inspect the following components.
NOTE • Tie Rod Ends q
Check front end alignment whenever steering • Steering Shaft U-Joints w
components are replaced. • Steering Gearbox e

WARNING

Due to the critical nature of the procedures outlined in
this chapter, Polaris recommends steering component
repair and adjustment be performed by an authorized
Polaris MSD certified technician.

2.30 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.