Page 66 - Manual Oficina XP 1000 14-16

MAINTENANCE

5. Measure the distance between the marks and WHEEL TOE ADJUSTMENT
record. Call this measurement e. Subtract If toe alignment is incorrect, repeat steps 3-5 of “Wheel
measurement e from measurement w, this is the Toe Alignment Inspection”, but instead measure the
vehicle toe. The recommended vehicle toe tolerance distance between each wheel and the vehicle center.
is 1/8 to 3/16″ (3.2 to 4.8 mm) toe out. This means This will tell you which tie rod needs adjusting.
the measurement at the front of the tire w is wider
than the measurement at the rear e.
MEASUREMENT
Wheel Toe-Out:
1/8" to 3/16″ (3.2 to 4.8 mm)

NOTE

Be sure steering wheel is straight ahead before
determining which tie rod needs adjustment.

CAUTION
During tie rod adjustment, it is very important that the
following precautions be taken when tightening tie rod
end jam nuts.
If the rod end is positioned incorrectly it will not pivot,
and may break.

To adjust toe alignment:
• Hold tie rod end to keep it from rotating.
• Loosen jam nuts at both end of the tie rod.
• Shorten or lengthen the tie rod until alignment is as
required to achieve the proper toe setting as specified
in “Wheel Toe Alignment”.
• IMPORTANT: When tightening the tie rod end jam
nuts, the rod ends must be held parallel to prevent rod
end damage and premature wear. Damage may not be
immediately apparent if done incorrectly.
• After alignment is complete, torque jam nuts to
specification.
TORQUE
Tie Rod Jam Nut:
14 ft-lbs (19 Nm)

2.32 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.