Page 277 - Manual Oficina Polaris RZR XP 1000 17-18

PVT SYSTEM

7. Remove and inspect limiter spacer(s) e. Replace if NEEDLE BEARING INSPECTION
necessary. 1. Rotate the clutch bearing. The non-braking needle
bearing should rotate on the shaft with only a slight
CAUTION
amount of drag.
DO NOT reassemble the drive clutch without the limiter
spacer. Belt life will be greatly reduced. IMPORTANT
The clutch bearing is a one-way bearing.
Drive Clutch Spring Inspection
2. Verify there is no binding or rough spots. If problems
CAUTION are noted continue with disassembly.
Never shim a drive clutch spring to increase its
compression rate. This may result in complete stacking
of the coils and subsequent clutch cover failure.

The drive clutch spring is one of the most critical
components of the PVT system. It is also one of the
easiest to service. Due to the severe relaxation the
spring is subject to during operation, it should always
be inspected for tolerance limits during any clutch 5
operation diagnosis or repair.
Check to see that spring coils are parallel to one
another using a straight-edge. Distortion of the
spring indicates stress fatigue, requiring
replacement.

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 5.17
© Copyright Polaris Industries Inc.