Page 442 - Manual Oficina Polaris Sportsman 570 2014 a 2016

PVT SYSTEM

15. Use a T25 Torx driver to install the four helix 3. Remove the drive belt. Verify the belt is not worn,
retaining screws and torque to specification. burned, dished, or glazed.

IMPORTANT
TORQUE
Ensure the correct belt is used. Belt part number should
Helix Retaining Screws: be 3211113.
42-52 in. lbs. (4.75 - 5.88 Nm)

4. Measure the projected width of the drive belt. Use a
straight edge across the top of the belt to provide a
EBS CLUTCH ALIGNMENT more accurate measurement. Replace if necessary.
If creeping or difficult shifting is experienced at idle, MEASUREMENT
perform the following clutch offset adjustment procedure.
Proper clutch offset should yield at least .025" clearance Maximum Drive Belt Width:
to the sheave on both side of the belt. 1.219” (30.96 mm)

1. Remove the outer clutch cover. Refer to Disassembly,
page 5.16. 5. Remove the driven clutch bolt q, thrust washer w,
and offset washer(s) e.
2. Inspect the drive belt to determine if the belt is riding
on the stationary or movable sheave. The belt should
be centered between the sheaves.

IMPORTANT
Ensure the inner and outer tapers are clean and free of
chips or burrs.

5.56 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.