Page 696 - Manual Oficina Polaris Sportsman 570 2014 a 2016

ELECTRICAL

STARTER MOTOR INSTALLATION STARTER SOLENOID BENCH TEST
1. Inspect and replace starter motor O-ring if needed. Test the start solenoid by powering the solenoid using
battery voltage for a maximum of 5 seconds. With the
2. Lubricate the starter motor O-ring with fresh engine solenoid energized, resistance should read about 0 - 0.5
oil.
Ohms between terminals (A) and (B). If resistance
3. Place the lower starter motor fastener through the measurement is out of specification, replace the starter
lower mounting boss in the starter motor. solenoid.
4. Install the starter motor onto the engine case.
5. Install the (-) negative battery cable in the upper
starter bolt and hand tighten the upper starter
mounting bolt.

6. Install and torque the lower mounting bolt to
specification.
NOTE
Tighten the lower starter bolt first, as the bottom hole
acts as a pilot hole to properly align the starter drive
(bendix) with the flywheel. This helps prevent binding
and starter damage.

7. Torque the upper starter mounting bolt to
specification. STARTER SOLENOID OPERATION
To energize the Starter Solenoid the following must
TORQUE
occur:
Starter Motor Bolts: • The brake must be applied to provide a ground path
7 ft-lbs (10 Nm) via the Orange wire.
• The key switch must be turned to the “start” position to
8. Connect the (-) negative battery cable, install the provide 12V power via the Green / White wire.
seat, and left side panel. • Once the coil is energized, the solenoid provides a
current path for 12V power to reach the starter motor.

11.34 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.