Page 701 - Manual Oficina Polaris Sportsman 570 2014 a 2016

ELECTRICAL

VOLTAGE REGULATOR / RECTIFIER 6. Disconnect the voltage regulator wiring harness e
The Regulator / Rectifier is located in the left front wheel from the voltage regulator wiring harness at the
well, in front of the left front wheel. connection t fastened to the engine mount. Remove
the voltage regulator wiring harness by removing the
NOTE retention points wr and t .
If the regulator / rectifier overheats, the unit will turn NOTE
itself off to cool down. The unit will turn on again after it
has cooled down. If it turns off, verify the cooling fins Note routing and retention points for installation.
are clean, free from debris and that adequate airflow is
present.

REMOVAL

CAUTION
Whenever removing or reinstalling the battery,
disconnect the negative (black) cable first and reinstall
the negative (black) cable last!

1. Disconnect the battery negative (-) terminal.
2. Disconnect the battery positive (+) terminal.
3. Remove the front rack.
7. Remove the fasteners retaining the voltage regulator
4. Remove the center panel under the pod.
and heat sink.
5. Disconnect the voltage regulator wiring harness q at
the terminal block. Remove the voltage regulator INSTALLATION
wiring harness q, note the fastening locationsq for 1. Align the voltage regulator q and heat sink w on the
installation. chassis e and install the fasteners r that retain the
assembly.
NOTE
Note routing and retention points for installation.

2. Install the fasteners that retain the voltage regulator.
Torque to specification.
11
TORQUE
Voltage Regulator Fasteners:
75 in. lbs. (7 Nm)

9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual 11.39
© Copyright Polaris Industries Inc.