Page 354 - Manual Oficina Polaris RS1 2018 e 2019

STEERING / SUSPENSION

STEERING WHEEL REMOVAL POWER STEERING UNIT REMOVAL

1. Remove the upper steering shaft, pivot tube and 1. Remove the upper steering shaft, pivot tube and
steering wheel as an assembly before attempting to steering wheel from the vehicle as an assembly.
remove the steering wheel. Refer to “Upper Steering Refer to “Upper Steering Shaft Removal” outlined in
Shaft Removal” outlined in this chapter. this chapter.
CAUTION CAUTION

Striking the steering wheel or steering shaft while Striking the steering wheel or steering shaft while
installed in the vehicle can permanently damage the installed in the vehicle can permanently damage the
EPS unit and cause a Power Steering Fault. EPS unit and cause a power steering fault.

2. Remove the steering wheel cap. 2. Disconnect the two electrical harnesses q from the
power steering unit.

3. Loosen the nut and back it half way off the steering
shaft.
4. Place the assembly in a vise.
5. Using a large bronze drift and hammer, strike the
steering shaft nut to pop the steering wheel off the
shaft taper.

6. Once the steering wheel pops loose, completely
remove the nut and lift the steering wheel off the
shaft.

8.6 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.