Page 248 - Manual Oficina Polaris RZR 570 13-18

PVT SYSTEM

DRIVE CLUTCH DISASSEMBLY 4. Inspect cover bushing q . The outer cover bushing is
manufactured with a Teflon™ coating. Wear is
1. Using a permanent marker, mark the cover, spider, determined by the amount of Teflon™ remaining on
and moveable and stationary sheaves for reference, the bushing.
as the cast in X's may not have been in alignment
before disassembly.

Cover Bushing Inspection:
Replace the cover bushing if more brass than Teflon™
2. Mark the stationary sheave and clutch shaft to verify
the shaft has not turned in the sheave after tightening is visible on the bushing. Refer to bushing replacement
the spider during clutch assembly. in this chapter.

5. Inspect area on shaft where bushing rides for wear,
galling, nicks or scratches. Replace clutch assembly
if worn or damaged.
6. Remove and inspect the clutch spring w. See “Drive
Clutch Spring Specifications” for spring inspection.

IMPORTANT
Upon reassembly, if the reference marks created in
step 2 are not in alignment, the clutch will not be in
balance and the assembly MUST be replaced.

3. Remove the six cover bolts evenly in a cross pattern 7. Remove the limiter spacer e and inspect for wear.
and remove cover plate. Replace if excessive wear is evident.

5.16 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.