Page 249 - Manual Oficina Polaris RZR 570 13-18

PVT SYSTEM

8. Inspect area on shaft r where bushing rides for
wear, galling, nicks, or scratches. Replace clutch
assembly if worn or damaged.

SHIFT WEIGHT INSPECTION
Remove shift weight bolts and weights. Inspect the
contact surface of the weight q. The surface should be
CAUTION smooth and free of dents or gall marks. Inspect the
weight pivot bore and bolts w for wear or galling. If 5
DO NOT reassemble the drive clutch without the limiter weights or bolts are worn or broken, replace in sets of
spacer e. Belt life will be greatly reduced.
three with new bolts and nuts.
Drive Clutch Spring Inspection

CAUTION
Never shim a drive clutch spring to increase its
compression rate. This may result in complete stacking
of the coils and subsequent clutch cover failure.

The drive clutch spring is one of the most critical
components of the PVT system. It is also one of the
easiest to service. Due to the severe relaxation the
spring is subject to during operation, it should always be
inspected during any clutch operation diagnosis or repair.
Check to see that spring coils are parallel to one another.
Distortion of the spring indicates stress fatigue, requiring
replacement.
CAUTION
The clutch assembly is a precisely balanced unit. Never
replace parts with used parts from another clutch
assembly!

9926813 R06 - 2013-2016 RZR 570 Service Manual 5.17
© Copyright Polaris Industries Inc.