Page 252 - Manual Oficina Polaris RZR 570 13-18

PVT SYSTEM

2. Inspect sheave surfaces. Replace the entire clutch if DRIVE CLUTCH INSPECTION
worn, damaged or cracked.
NOTE
BEARING INSPECTION Remove cover, spring, and spider following instructions
for drive clutch removal, then proceed as follows:
1. Rotate the clutch bearing in both clockwise and
counter-clockwise directions.
• Non-EBS: The non-braking bearing should rotate 1. Remove the moveable sheave spacer sleeve q .
both directions on the shaft with only a slight Inspect for damage and wear.
amount of drag.
• EBS: The one-way bearing should rotate clockwise
(when viewed from cover plate side) with only a
slight amount of drag. When rotated counter-
clockwise the one-way bearing should lock to the
shaft without slipping.
2. Verify there is no binding or rough spots. If problems
are noted continue with disassembly.

2. Remove the moveable clutch sheave w . Inspect for
damage and wear.

5.20 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.