Page 254 - Manual Oficina Polaris RZR 570 13-18

P. 254

PVT SYSTEM

5. Install main adapter (D) onto puller.

NOTE
Bushings are installed at the factory using Loctite® 648. 6. With towers pointing toward the vise, slide sheave
In order to remove bushings it will be necessary to onto puller rod.
apply heat evenly to the area around each bushing.
Clean all residual Loctite® from bushing bore prior to 7. Install bushing removal tool into center of sheave with
installing new bushing. small side toward sheave.
NOTE
CAUTION Bushing Tool:
PA-47336
Clutch components will be hot! In order to avoid serious
burns, wear insulated gloves during the removal
process. 8. Install nut (C) onto end of puller rod and hand tighten.
Turn puller barrel to increase tension on sheave if
needed. Using a hand held propane torch, apply heat
Moveable Sheave - Bushing Removal around outside of bushing until tiny smoke tailings
1. Remove clutch as outlined previously in this chapter. appear.
2. Install handle end of the Piston Pin Puller securely 9. Turn sheave counterclockwise on puller rod until it
into bench vise and lightly grease puller threads. comes free. Lift sheave off puller.
10.Remove nut from puller rod and set aside.
11. Pull bushing removal tool and adapter from puller rod.
Remove bushing from tool and discard.

Moveable Sheave - Bushing Installation
12.Apply Loctite® 648 evenly to bushing bore inside
moveable sheave.
13.Set bushing in place on sheave.
14.Insert bushing tool (PA-47336) with small side down,
into center of bushing.
15.With towers pointing upward, slide sheave, bushing
and tool onto puller rod.
16.Install nut on puller rod and hand tighten. Turn barrel
Piston Pin Puller: to apply additional tension if needed.
2870386 17.Turn sheave counterclockwise, making sure bushing
is drawn straight into bore. Continue until bushing is
3. Remove nut from puller rod and set aside. seated.
4. Install puller adapter from kit PN 2871226). 18.Remove nut from puller rod and set aside.

249 250 251 252 253 254 255 256 257 258 259