Page 336 - Manual Oficina Polaris RZR 570 13-18

FINAL DRIVE

5. Remove the two front brake caliper mounting bolts 9. Remove the bearing carrier from the front drive shaft.
y and remove the caliper from the brake disc.

10. With a short, sharp jerk, remove drive shaft from the
front gearcase.
CAUTION
Do not hang the caliper by the brake line. Use wire to
hang caliper to prevent damage to the brake line.

6. Remove the front wheel hub assembly.
7. Remove the upper and lower ball joint pinch
fasteners u.

FRONT DRIVE SHAFT INSTALLATION
1. Install new spring ring on drive shaft. Apply an anti-
seize compound to splines.
2. Align splines of drive shaft with front gearcase and
reinstall the drive shaft. Use a rubber mallet to tap on
the outboard end of the drive shaft if necessary
8. Using a soft faced hammer, lightly tap on the bearing
carrier while removing the upper and lower ball joint 3. Install drive shaft into the front bearing carrier.
ends. 4. Install the ball joint ends into the front bearing carrier.

7.12 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.