Page 338 - Manual Oficina Polaris RZR 570 13-18
P. 338

FINAL DRIVE


                4. Remove and discard the two brake caliper mounting  7. Rotate the top of the bearing carrier down and
                   bolts r.                                              remove the rear drive shaft.





















                                                                     8. Slide the rear drive shaft out of the bearing carrier by
                                   CAUTION                               pulling the bearing carrier assembly outward and
                  Do not hang the caliper by the brake line. Use wire to  tipping it down to remove the shaft.
                   hang caliper to prevent damage to the brake line.
                                                                     9. Grasp the rear drive shaft and pull sharply outward
                                                                         on the shaft to disengage it from the rear gearcase.
                5. Remove the rear wheel hub/disc assembly.






















                6. Remove the nut, washer and bolt t retaining the                       CAUTION
                   rear bearing carrier to the upper A-arm. Discard nut  Use caution when removing to prevent damaging the
                   and replace with new. Loosen the lower bearing                       gearcase seal.
                   carrier mounting fasteners y.
                                                                     10. Inspect the axle splines and CV boots for any
                                                                         damage.

                                                                     REAR DRIVE SHAFT INSTALLATION
                                                                     1. Install new spring ring on drive shaft. Apply anti-
                                                                         seize compound to splines.
                                                                     2. Align splines of drive shaft with rear gearcase and
                                                                         reinstall the drive shaft. Use a rubber mallet to tap on
                                                                         the outboard end of the drive shaft if necessary.

                                                                                         CAUTION
                                                                       Use caution when installing the drive shaft to prevent
                                                                                      damaging the seal.





                7.14                                                               9926813 R06 - 2013-2016 RZR 570 Service Manual
                                                                                               © Copyright Polaris Industries Inc.
   333   334   335   336   337   338   339   340   341   342   343