Page 339 - Manual Oficina Polaris RZR 570 13-18

FINAL DRIVE

3. Slide the rear drive shaft into the rear bearing carrier. 7. Install NEW brake caliper mounting bolts r and
torque to specification.
4. Lift bearing carrier into place and install the bolt
attaching the bearing carrier to the upper A-arm.
Torque upper and lower fasteners t to specification.

TORQUE
Rear Caliper Mounting Bolts:
TORQUE 44 ft-lbs (60 Nm)
Rear Bearing Carrier Fasteners:
40 ft-lb (54 Nm) CAUTION

New bolts have a pre-applied locking agent which is
5. Apply grease to drive shaft axle splines.
destroyed upon removal. Always use new brake caliper
6. Install rear wheel hub assembly, cone washers e, mounting bolts upon assembly.
and hand tighten the castle nut w. Install washers
with domed side out. 8. Torque wheel hub nut to specification and install a 7
NEW cotter pin. Tighten nut slightly if necessary to
align cotter pin holes.

TORQUE
Rear Wheel Hub Castle Nut:
110 ft-lbs (149 Nm)

9. Install wheel and four wheel nuts. Torque wheel nuts
to specification.
TORQUE
Wheel Nuts:
RZR 570 Steel Rims: 36 ft-lbs (49 Nm)
RZR 570 EPS Alum. Rims: 120 ft-lb (163 Nm)
RZR S 570 Alum. Rims: 30 ft-lbs (41 Nm) + 90°

9926813 R06 - 2013-2016 RZR 570 Service Manual 7.15
© Copyright Polaris Industries Inc.