Page 371 - Manual Oficina Polaris RZR 570 13-18

STEERING / SUSPENSION

UPPER STEERING SHAFT INSTALLATION 5. Install a new upper steering shaft pinch bolt and nut.
(EPS) Torque pinch bolt to specification.
TORQUE
NOTE
Upper Steering Shaft Pinch Bolt:
If steering wheel was removed, follow this procedure to 16 ft-lbs (22 Nm)
ensure the upper steering shaft is properly positioned
on the power steering stub shaft.
6. Reconnect both electrical harnesses onto the power
steering unit. Be sure the connectors snap into
place.
CAUTION
7. Reinstall the black plastic cover over the power
Striking the steering wheel or steering shaft can
permanently damage the EPS unit and cause a Power steering unit and install the two Torx-head fasteners.
Steering Fault. 8. Turn the key switch on and test EPS operation.

1. Install the upper steering shaft and align the skip-
tooth spline on the power steering stub shaft with the
opening in the upper steering shaft.

2. Install pivot tube and torque fasteners to 8
specification.
TORQUE
Pivot Tube Fasteners:
23 ft-lb (31 Nm)

3. Install tilt shock and torque fastener to specification.
TORQUE
Tilt Shock Fastener:
7 ft-lbs (10 Nm)

4. Be sure the front wheels are pointing straight ahead
and install the steering wheel and retaining nut.
Torque the nut to specification and reinstall the
plastic wheel cover.
TORQUE
Steering Wheel Nut:
65 ft-lbs (88 Nm)

9926813 R06 - 2013-2016 RZR 570 Service Manual 8.11
© Copyright Polaris Industries Inc.