Page 375 - Manual Oficina Polaris RZR 570 13-18

STEERING / SUSPENSION

BALL JOINT SERVICE PREPARATION BALL JOINT REMOVAL

NOTE NOTE

Do not reuse a ball joint if it has been removed. If Do not reuse a ball joint if it has been removed. If
removed, it must be replaced. Use this removal removed, it must be replaced. Use this removal
procedure only when replacing the ball joint. procedure only when replacing the ball joint.
Ball joint tool PU-50506 will allow the upper and lower Ball joint tool PU-50506 (shown below) will allow the
ball joints to be replaced with the A-arm installed on the upper and lower ball joints to be replaced with the A-
vehicle. arm installed on the vehicle.

The A-arm does not need to be removed to perform this The A-arm does not need to be removed to perform this
procedure if ball joint tool PU-50506 is used. procedure if ball joint tool PU-50506 is used.
1. Properly lift and support the vehicle by the frame. 1. Properly lift and support the vehicle by the frame.
2. Remove the appropriate front wheel. 2. Remove the appropriate front wheel.
3. Remove and discard the ball joint pinch bolt. 3. Remove and discard the ball joint pinch bolt.
4. Remove the retaining ring q from the ball joint.
8

9926813 R06 - 2013-2016 RZR 570 Service Manual 8.15
© Copyright Polaris Industries Inc.