Page 365 - Manual_Polaris_RZR_ProXP-20-21

FINAL DRIVE

6. Remove the lower radius rod outer mounting bolt y, 9. Remove the five remaining bolts i that attach the
nut and washer from the bearing carrier. Swing radius rear bearing carrier to the trailing arm. Discard the
rod down. nuts.

7. Remove the two brake caliper mounting bolts u. 10.Remove the bearing carrier from the rear drive shaft
Remove the rear brake caliper assembly. and trailing arm.

8

11. Rotate bearing by hand and check for smooth
CAUTION
rotation. Visually inspect bearing for moisture, dirt, or
Do not hang the caliper by the brake line. Use wire to corrosion.
hang caliper to prevent damage to the brake line.
IMPORTANT
Due to extremely close tolerances and minimal wear,
8. Remove the rear wheel hub and brake disk assembly. the bearings must be inspected visually, and by feel.
A two-jaw puller may be required to separate the half While rotating bearings by hand, inspect for rough
shaft splines from the hub.
spots, discoloration, or corrosion. The bearings should
turn smoothly and quietly, with no detectable up and
down movement and minimal movement sideways
between inner and outer race.

12.Replace bearing if moisture, dirt, corrosion, or
roughness is evident.

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 8.7
© Copyright Polaris Industries Inc.