Page 366 - Manual_Polaris_RZR_ProXP-20-21

FINAL DRIVE

REAR BEARING REPLACEMENT 6. Apply Loctite 603 to the circumference of the new
®
™
Bearing Removal bearing race e.
1. Remove the outer snap ring q.

7. Carefully press the new bearing into the bearing
carrier housing w.
2. Press bearing out using a hydraulic press and
appropriately sized adapter.

NOTICE
3. Inspect the bearing carrier housing for scratches, Use care to not allow any of the Loctite compound to
®
wear or damage. Replace rear bearing carrier if get in the bearing.
damaged.
Bearing Installation 8. Wipe the housing clean of any excess compound
4. Thoroughly clean the rear bearing carrier housing and install the snap ring r.
and the outer race on the new bearing. Be sure that 9. Allow Loctite to cure for at least 3 hours before
all oil and Loctite residue has been removed from vehicle operation.
each surface.
5. Support the bottom of the bearing carrier housing.

CAUTION
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.

8.8 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.