Page 259 - Manual Oficina XP 1000 14-16

PVT SYSTEM

2. Install the shaft and bearing assembly into the outer 5. Install the roller pin into the sheave assembly on both
sheave using an arbor press. sides. The flat side of the roller pin faces towards the
sheaves.

NOTE 6. Install the spring pins t to secure the roller pins.
Press only on the outer race of the bearing during Install until flush with sheave surface. 5
installation to prevent damaging the bearing.

3. Line up the X on the moveable sheave with the X on
the stationary sheave. Put the sheaves together.

7. Install the spring over the shaft.
8. Install the clutch rollers y onto each side of the
spider. Install the washers u and E-clips i to secure
the rollers. The rollers should spin freely.
4. Install the rollers e onto the roller pins r and install
on the clutch.

9. Install the spider dampener o inside the spider and
install the inside spider plate a.

9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 5.35
© Copyright Polaris Industries Inc.