Page 132 - Manual Oficina Polaris RZR XP 1000 17-18

ENGINE / COOLING SYSTEM

ENGINE REMOVAL 10. Remove the outer clutch cover screws w and
remove the cover from the vehicle.
NOTE
Some engine repair procedures can be performed
without removing the engine assembly from the vehicle.
Refer to Accessible Engine Componentspage 3.21 for
further information.
The use of an overhead or portable engine hoist is the
only recommended method for removing and installing
the engine.
Have an assistant help guide the engine in and out of
the vehicle while using an engine hoist to prevent
personal injury or damage to vehicle components.

WARNING
Always wear safety glasses and proper shop clothing 11. Remove drive belt, drive clutch, driven clutch, inner
when performing the procedures in this Service clutch cover and clutch outlet duct (see Chapter 5 –
Manual. Failing to do so may lead to possible injury. PVT Disassemblypage 5.9).

1. If vehicle was recently operated, allow it to cool down CAUTION
before attempting to perform any work.
Correct Drive Clutch Puller P/N 2872085
2. Thoroughly clean the engine and chassis.
3. Drain the engine oil and coolant prior to engine
removal (See Chapter 2 – Coolant Drain / Fillpage
2.40).

4. Remove the seats.
5. Disconnect the (-) negative battery cable from the
battery.
6. Remove the rear bumper and cargo box (see
Chapter 10 – Cargo Box Assembly Removalpage
10.23).
7. Remove the air box assembly.
8. Elevate the rear of the vehicle off the ground using a
suitable lift and remove the left rear wheel.

WARNING
Use care when supporting vehicle so that it does not tip NOTE
or fall. Serious injury may occur if vehicle tips or falls.
Be sure to use the correct Drive Clutch Puller (PN
2872085) to prevent damage to crankshaft.
9. Remove lower mounting bolt q from the left rear
shock and discard the nut. Install a new nut upon
assembly.

3.24 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.