Page 286 - Manual Oficina Polaris RZR XP 1000 17-18

PVT SYSTEM

DRIVEN CLUTCH SERVICE

DRIVEN CLUTCH SLIDER INSPECTION DRIVEN CLUTCH DISASSEMBLY
The square sliders can be inspected with the driven
clutch installed on the vehicle. 1. Remove driven clutch from the transmission input
shaft.
Using a feeler gauge, measure the distance between the
slider and the stationary sheave at the widest point q. If 2. It is important to mark the position of the helix cover,
the measurement is over the service limit, the sliders or sheaves and spider with a tape or grease marker (as
driven clutch will need to be replaced. Also measure the shown) before disassembly. Some components will
width of the slider block w. Replace the sliders if they are have X’s on the components for alignment reference.
smaller than the service limit. This helps with clutch assembly and maintains clutch
balance.

MEASUREMENT
3. Place the driven clutch (helix side up) into the
Slider to Sheave Clearance q: Universal Clutch Compressor.
Service Limit: 0.175″ (4.5 mm)

Slider Width w:
Service Limit: 0.975″ (24.8 mm)

Universal Clutch Compressor: PU-50518-A

5.26 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.