Page 340 - Manual Oficina Polaris RZR XP 1000 17-18

FINAL DRIVE

12. Lower the trailing arm. 2. Align splines of drive shaft with transmission splines
and reinstall the drive shaft. Use a rubber mallet to
tap on the outboard end of the drive shaft if
necessary.

13. With a short, sharp jerk, remove drive shaft from the
transmission splines.

3. Swing the rear trailing arm assembly outward and
upward until the rear axle can be inserted into the
bearing carrier. Support the trailing arm from
underneath.

REAR DRIVE SHAFT INSTALLATION
1. Install new spring ring q on drive shaft. Apply an
anti-seize compound to the splines w.
4. Install the lower shock mounting bolt and new nut.
Torque fastener to specification.

TORQUE
Lower Shock Bolt to Trailing Arm:
70 ft-lbs (95 Nm)

5. Install the stabilizer bar mounting bolt, washer and
new nut. Torque fastener to specification.
TORQUE
Stabilizer Bar Linkage:
40 ft-lbs (54 Nm)

6. Apply Anti-Seize to drive shaft axle splines.

7.14 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.