Page 342 - Manual Oficina Polaris RZR XP 1000 17-18

FINAL DRIVE

DRIVE SHAFT / CV JOINT HANDLING TIPS CV JOINT SERVICE
Care should be exercised during drive shaft removal or
when servicing CV joints. Drive shaft components are OUTER CV BOOT REPLACEMENT
precision parts.
Cleanliness and following these instructions is very NOTICE
important to ensure proper shaft function and a normal Outer CV Joint replacement is not recommended. If the
service life. outer joint is damaged, a new half shaft assembly
should be installed.
• The complete drive shaft and joint should be handled
by getting hold of the interconnecting shaft to avoid
disassembly or potential damage to the drive shaft 1. Use a side cutters to cut and discard the boot clamps
joints. q.
• Over-angling of joints beyond their capacity could
result in boot or joint damage.
• Make sure surface-ground areas and splines of shaft
are protected during handling to avoid damage.
• Do not allow boots to come into contact with sharp
edges or hot engine and exhaust components.
• The drive shaft is not to be used as a lever arm to
position other suspension components.
• Never use a hammer or sharp tools to remove or to
install boot clamps.
• Be sure joints are thoroughly clean and that the proper
amount and type of grease is used to refill when joint
boots are replaced and when joints are cleaned. Refer
to text for grease capacity of CV joints and CV joint 2. Remove the large end of the boot from the CV joint
boots. and slide the boot down the shaft.

7.16 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.