Page 344 - Manual Oficina Polaris RZR XP 1000 17-18

FINAL DRIVE

INNER PLUNGING JOINT / BOOT 5. Pull the shaft / joint straight out from the housing.
REPLACEMENT

1. Use a side cutters to cut and discard the boot clamps
q.

CAUTION
Do NOTstrike the joint with a hammer.

2. Remove the large end of the boot from the plunging 6. Remove the snap ring w retaining the cage / ball
joint and slide the boot down the shaft. assembly and remove the assembly from the shaft.

3. Remove the large circlip near the boot end of the 7. Remove the boot from the shaft.
plunging joint.
CAUTION
4. Clean the grease from the face of the joint.
Complete disassembly of the plunging joint is NOT
recommended. The internal components are precision
fit and develop their own characteristic wear patterns.
Intermixing the internal components could result in
looseness, binding, and/or premature failure of the joint.

IMPORTANT

If the grease in the joint is obviously contaminated with
water and/or dirt, the joint should be replaced.

7.18 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.