Page 360 - Manual Oficina Polaris RZR XP 1000 17-18

FINAL DRIVE

14. Inspect the roll cage assembly j sliding surfaces FRONT GEARCASE ASSEMBLY
and H-springs l. The sliding surfaces must be clean 1. As mentioned during gearcase disassembly section,
and free of nicks, burrs or scratches. If damaged, replace all O-rings, seals and worn components.
replace the roll cage assembly.
2. Install pinion shaft assembly and install internal snap
ring.

NOTICE
If bearing replacement was required, press new bearing
onto the pinion shaft and install a new external snap
ring.

3. Install a new pinion shaft seal q into the pinion gear
housing. Using a universal seal installer, press the
new seal into the housing until the seal is just below
the housing chamfer.

15. Inspect both output hub assemblies. Inspect the
bearings and replace if needed.

4. Install the RH output hub w into the gearcase
housing.

1( Bearing 2! Roller Surface

2) Spacer 2@ Thrust Bearing

16. Clean and inspect all remaining front gearcase
components. Check each for excessive wear or
damage.

7.34 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.