Page 362 - Manual Oficina Polaris RZR XP 1000 17-18

FINAL DRIVE

9. Install armature plate u. Be sure all of the armature 12. Carefully install the LH output hub assembly o into
plate tabs are fully engaged into the roll cage the cover plate. Take care not to damage the new
assembly and that it is resting properly on the torsion cover plate seal while installing the output hub.
spring retainer.

13. Install the output cover assembly a onto the
gearcase housing. Install the seven cover plate
NOTICE
screws s and torque to specification.
Verify armature plate tabs are in the roll cage slots and
that it rests properly on the spring retainer.

10. Carefully install the ring gear and roll cage assembly
i into the gearcase housing.

11. Install a new O-ring on the cover plate assembly.
NOTICE

Be sure the square O-ring is placed flat on the cover
surface. If the O-ring is twisted fluid leakage may occur.

TORQUE
Cover Plate Screws:
9 ft-lbs (12 Nm)

7.36 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.