Page 363 - Manual Oficina Polaris RZR XP 1000 17-18

FINAL DRIVE

FRONT GEARCASE INSTALLATION 6. Connect the AWD wire harness.
1. Install the gearcase back into the vehicle through the
LH wheel well area, above the upper A-arm.

7. Refer to FRONT DRIVE SHAFT - Drive Shaft
2. Lubricate the front gearcase splines with Anti-Seize. Installationpage 7.12 and install both front drive
shafts into the gearcase.
3. Install the prop shaft onto the front gearcase input
shaft. Use a NEW spring pin in the front propshaft. 8. Add the proper lubricant to the front gearcase. Refer
to Chapter 2 for fluid fill and change information.
4. Install the four bolts q that secure the front gearcase
to the frame and torque to specification. FLUID CAPACITY
TORQUE Recommended Front Gearcase Fluid:
Demand Drive Fluid 2877922 (quart)
Front Gearcase Mounting Bolts:
35 ft-lbs (47 Nm)
Capacity:8.5 oz (250 mL) 7
(fill on a level surface to bottom of threads on the fill
5. Install the vent line w.
hole)

FRONT GEARCASE VENT LINE ROUTING
The front gearcase vent line starts at the front gearcase
q and routes up the right side. The vent line is secured
by one retaining clip w and is routed through a hole in
the frame support e behind the radiator.

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 7.37
© Copyright Polaris Industries Inc.