Page 518 - Manual Oficina Polaris RZR XP 1000 17-18

ELECTRICAL

HEADLAMP INSTALLATION 2. While holding the taillight assembly, remove the
1. Install the headlamp adjustment springs onto the three nuts w retaining the taillight assembly and
front bumper mounting bosses. remove it from the rear fascia.
2. Insert the three T-25 headlamp mounting screws into DASH LIGHT
the headlamp assembly mounting holes.
The LED light will remain ON for approximately 30
3. Maneuver the headlamp assembly into position. Be seconds after key has been switched to the OFF
sure all three headlamp springs w and mounting position.
screws q are properly aligned with mounting bosses
e on the front bumper.

4. Fully tighten all three headlamp screws until the
headlamp assembly is fully seated. Back headlamp
mounting screws off 1/8” to 1/4” (2-3 turns).

5. Install the front bumper as shown in Chapter 5 if
previously removed.
6. Connect headlamp electrical connector to the
headlamp assembly.
7. Perform the “Headlight Adjustment” procedure as
shown in this chapter.

TAILLIGHT REPLACEMENT
Before replacing the taillight(s), use a digital multi-meter
to test the harness to ensure the lamp is receiving 12
volts and that a ground path is present.
1. Disconnect the wire harness q.

11.50 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.