Page 362 - Manual_Polaris_RZR_ProXP-20-21

FINAL DRIVE

FRONT BEARING REPLACEMENT 3. Apply Loctite 603 to the circumference of the new
®
™
Bearing Removal bearing race q.
1. Remove inner snap ring q.

IMPORTANT
Ensure Loctite is applied around the entire
2. Press bearing out using a hydraulic press and circumference of the bearing. An acid brush can be
appropriately sized adapter. used to assist in even application.

4. Carefully press the new bearing into the bearing
carrier housing.

3. Inspect the bearing carrier housing for scratches,
wear, or damage. Replace front bearing carrier if
damaged.
Bearing Installation
NOTICE
1. Thoroughly clean the front bearing carrier housing Use care to not allow any of the Loctite compound to
®
and the outer race on the new bearing. Be sure that get in the bearing.
all oil and Loctite residue has been removed from
each surface.
5. Wipe the housing clean of any excess compound and
2. Support the bottom of the bearing carrier housing
install the snap ring w.
CAUTION 6. Allow Loctite to cure for at least 3 hours before
vehicle operation.
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.

8.4 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.