Page 364 - Manual_Polaris_RZR_ProXP-20-21

FINAL DRIVE

9. Torque wheel hub nut y to specification and install a REAR BEARING CARRIER INSPECTION
new cotter pin u. Tighten nut slightly if necessary to / REMOVAL
align cotter pin holes. Bend both ends of cotter pin
around end of spindle in different directions. 1. Elevate rear of vehicle and safely support machine
under the frame area.

WARNING
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure. Wear eye protection when removing
bearings and seals.

2. Check bearings for side play by grasping the top and
bottom of the tire firmly and checking for movement.
The tire should rotate smoothly without binding or
rough spots.
3. Remove the four wheel nuts and rear wheel.
4. Remove the cotter pin q and loosen the rear wheel
hub castle nut w. Remove the nut, and cone washer
TORQUE
e from the rear wheel hub assembly.
Wheel Hub Castle Nut:
180 ft-lbs (244 Nm)

10.Install wheel and four wheel nuts. Torque wheel nuts
to specification.

TORQUE
Wheel Nuts:
120 ft-lbs (163 N·m)

11. Rotate wheel and check for smooth operation.

5. Remove two fasteners r and remove the rear brake
line guide t.

8.6 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.