Page 501 - Manual Oficina Polaris RZR XP 1000 17-18

ELECTRICAL

Problem: Screen missing pixels, LCD screen flaw, software glitch or problem

STEP ACTION YES NO
Power cycle bike by switching ignition on and off with main power
1 switch in fairing. Go to Step 2 Go to Step 2
Did you find and repair the condition?

Update display with newest software available. Confirm
Refer to Update Software / Mapspage 11.31 for instructions on how to display
2 update/reflash software. operation and Go to Step 3
Is display working properly? continue use.
1. Remove and reinstall the 5amp fuse labeled INST in the main fuse
box under the left side upper panel.
3 Refer to Fuse Boxpage 11.59 Go to Step 2 Go to Step 4
Did you find and repair the condition?
Replace display with known good display. Repeat
4 Did you find and repair the condition? Go to Step 2 Diagnosis

GPS Antenna Troubleshooting
1. Unplug connector from GPS antenna and verify all contacts are securely seated in the connector.
2. Turn ignition on and make the following measurements on the antenna connector:

WIRING CONNECTION TO MEASURE VOLTAGE SPECIFICATION
Power Between Pins 4 and 3 12Vdc (Battery Voltage)

3. If antenna connector has 0Vdc supplied, check harness for loose connection or breaks in wiring. Check for power
at SW PWR fuse in fuse box.
4. If antenna connector shows proper voltage, check operation of GPS. If GPS still is not functioning, proceed to step
5.
5. Turn the ignition off and make the following measurements on the antenna connector:
6.
WIRING CONNECTION TO MEASURE RESISTANCE SPECIFICATION
CAN Between Pins 1 and 2 60 Ohms

7. If resistance value is out of spec, check for breaks in yellow/green CAN wiring.
8. If all values are within specification, replace GPS antenna with new unit.

11

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 11.33
© Copyright Polaris Industries Inc.