Page 502 - Manual Oficina Polaris RZR XP 1000 17-18

ELECTRICAL

SWITCHES

BRAKE LIGHT SWITCH HEADLAMP SWITCH
1. The brake light switch q is located on the front brake 1. Disconnect the headlamp switch harness by
line banjo bolt of the master cylinder. The brake depressing the connector locks and pulling on the
switch can be accessed through the left front wheel connector. Do not pull on the wiring.
well opening.
2. Test between the 3 sets of outputs (OFF / LOW /
HIGH). If any of the tests fail, replace headlamp
switch assembly.
• Move the switch to HIGH. There should be continuity
between switch pins 2 and 3; 5 and 6; 7 and 8.
• Move the switch to LOW. There should be continuity
between switch pins 2 and 3; 4 and 5; 7 and 8..
• Move the switch to OFF. There should be continuity
between switch pins 1 and 2; 4 and 5; 7 and 8.

2. Disconnect wire harness from switch and connect an
ohmmeter across switch contacts. The reading
should be infinite (OL).
3. Apply the brake and check for continuity. If there is
no continuity or if resistance is greater than 0.5
ohms, clean the switch terminals. Re-test and
replace switch if necessary.
4. For switch replacement, refer to Chapter 9 “Brakes”.

NOTICE
Pins 7 and 8 provide power and ground to light the
switch lamp.

11.34 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.