Page 268 - Manual Oficina Polaris RS1 2018 e 2019
P. 268
PVT SYSTEM
DRIVEN CLUTCH SERVICE
DRIVEN CLUTCH REMOVAL 6. Remove nine fasteners t and remove outer clutch
cover.
1. Remove left rear fender (see Rear Fender, page
10.12 in the Body / Frame chapter).
2. Raise the vehicle.
3. Remove four lug nuts q and remove left rear wheel.
7. Mark the drive belt direction of rotation so that it can
be installed in the same direction.
8. Insert clutch spreader tool into the driven clutch and
turn the tool clockwise to open the sheaves on the
4. Remove lower fastener w from rear left-hand shock driven clutch.
assembly, and pivot the shock out of the way.
NOTE
The driven clutch spreader tool is included with the
5. Loosen two worm clamps e and remove clutch vehicle’s tool kit.
intake duct r from the outer clutch cover.
9. Walk the belt out of the driven clutch and drive clutch.
Remove the belt from the vehicle.
10.Remove driven clutch spreader tool.
11. Remove the driven clutch retaining bolt y and
washer u.
5.16 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.
