Page 267 - Manual Oficina Polaris RS1 2018 e 2019
P. 267

PVT SYSTEM

                   DRIVE CLUTCH INSTALLATION                                                 TORQUE

                   1. Thoroughly  clean  the  drive  clutch  taper  and             Lower Shock Mounting Fastener
                      crankshaft post with solvent. Allow components to dry               70 ft-lbs (95 Nm)
                      completely before installation.
                   2. Install the drive clutch on the crankshaft. Hold the  10.Install rear left-hand wheel. Torque to specification.
                      clutch using the Drive Clutch Holding Tool. Torque
                      retaining bolt to specification.                                       TORQUE
                                 Drive Clutch Holding Tool:                                Wheel Lug Nuts
                                        PU-51861                                         120 ft-lbs (163 Nm)
                                                                         11. Install rear left-hand fender.
                                        TORQUE
                                Drive Clutch Retaining Bolt:
                                     96 ft-lb (130 Nm)

                   3. With the clutch spreader tool q installed, loop the
                      belt over the drive clutch and over part of the driven
                      clutch.
                                                                                                                              5




















                   4. Rotate the driven clutch and walk the belt into the
                      clutch.
                   5. Remove the clutch spreader tool from the driven
                      clutch.
                   6. Rotate / spin the driven clutch and belt approximately
                      5-7 times to properly seat the belt in the driven clutch.
                   7. Install outer clutch cover and nine screws. Torque to
                      specification.

                                        TORQUE
                                Outer Clutch Cover Screws:
                                      35 in-lb (3 Nm)

                   8. Install clutch intake duct, tighten two worm clamps to
                      specification.
                                        TORQUE
                                      Worm Clamps
                                     35 in-lbs (4 Nm)
                   9. Install rear left-hand shock into lower mounting point,
                      install lower fastener into shock, and torque to
                      specification.



                   9928689 - 2018 RZR RS1 Service Manual                                                              5.15
                   © Copyright Polaris Industries Inc.
   262   263   264   265   266   267   268   269   270   271   272