Page 340 - Manual Oficina Polaris RS1 2018 e 2019

FINAL DRIVE

14.Inspect the roll cage assembly sliding surfaces and FRONT GEARCASE ASSEMBLY
H-springs 1(. The sliding surfaces must be clean and
free of nicks, burrs, or scratches. If damaged, replace 1. As mentioned during gearcase disassembly section,
the roll cage assembly. replace all O-rings, seals, and worn components.
2. Install pinion shaft assembly and install internal snap
ring.
NOTE

If bearing replacement was required, press new bearing
into the pinion shaft and install a new external snap
ring.

3. Install a new pinion shaft seal q into the pinion gear
housing. Using a universal seal installer, press the
new seal into the housing until the seal is just below
the housing chamfer.

15.Inspect both output hub assemblies. Inspect the
bearings and replace if needed.

4. Install the RH output hub w into the gearcase
housing.

2) Bearing 2@ Thrust Bearing
2! Roller Surface

16.Clean and inspect all remaining front gearcase
components. Check each for excessive wear or
damage.

5. Install the plastic ring onto the clutch housing.

7.34 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.